Programming language: ...................................................... The logical configuration is performed using graphical functions based on the IEC

Lines of code*:........................................................................... 640 lines of code or 15360 bytes, whichever is greater (for versions < 7.00)

(*) Note: Reserved Modbus memory space of PLC equations in text format is up to 15360 bytes. This space is shared with information

configured in Enervista at Setpoint > Relay Configuration. According to this, the number of PLC equations can be limited by values

configured on that section.

Supported operations: .......................................................... NOT, XOR, OR (2 to 8 inputs), AND (2 to 8 inputs), NOR (2 to 8 inputs),

Libraries:....................................................................................... Logical gates fully programmable by user. Used to create user-programmable logic to

Inputs:............................................................................................ any logical variable, contact or virtual input

Number of Timers: .................................................................. 8 maximum in each logic scheme (provided in library format)

FLEXCURVES

Number: ....................................................................................... 4 (A through D)

Reset Points:............................................................................... 40 (0 through 1 of pickup)

Operate Point: ........................................................................... 80 (0 through 20 of pickup)

Time Delay:................................................................................. 0 to 65535 ms in steps of 1 ms

Saturation Level: ...................................................................... 20 x the pickup level

USER-PROGRAMMABLE LEDS

Number: ....................................................................................... 15 configurable LEDs plus the Ready non-configurable LED

Programmability:..................................................................... any logical variable, contact, or virtual input

Reset Mode:................................................................................ self-reset or latched.

Reset Signal:............................................................................... The LEDs can be reset by hardware, pressing the front "esc" key for more than 3

USER-DEFINABLE DISPLAYS

Number of Configurable Displays:.................................. 1: one line diagram fully configurable. In graphical displays only

Number of Fixed Displays: .................................................. 6: Metering (selectable between Primary and Secondary values), Snapshot Events (all

Number of Selectable Displays:........................................ 2: Logotype, Metering, or both in scrolling mode can be selected as the default screen

USER-PROGRAMMABLE FRONT KEYS

Number of Configurable Keys:.......................................... 5

Operation: ................................................................................... Drive PLC operands

GEK-113000-AF

61131-3 standard.

1000 total equations or 15360 bytes, whichever is greater (for versions >= 7.00)

NAND (2 to 8 inputs), Latch (Reset Dominant), Edge Detectors, Timers.

2 inputs default gates, from 3 to 8 inputs provided in library format.

Starting in version 7.20, analog operators are also available.

be distributed as a single object.

The first 5 LEDs (red) are latched by hardware, usually configured for trip signals.

The following 10 LEDs (yellow and green) are self-reset but can be latched through PLC