D.2 Factory Default Configuration - GE F650 User Manual

D.2 FACTORY DEFAULT CONFIGURATION

D.2 Factory default configuration
NOTE:
SOURCE COLUMN:
This columns allow selecting the simple or complex (OR signal or Virtual output) operand that actives the selected elements
on relay configuration
If more than one operands are selected, the relay performs an OR gate with them to activate the selected element.
SIGNAL LOGIC COLUMN:
Refers to each individual signal selected on its left. NOT legend means that the refered signal is inverted
SOURCE LOGIC COLUMN:
Refers to the whole SOURCE signal selected on its left. NOT legend means that SOURCE signal is inverted
If more than one operand were selected, the OR gate output is inverted
SETPOINT > RELAY CONFIGURATION > OUTPUTS
OUTPUT SOURCE
CONT OP OPER_F_01 VO_000_PROTECTION_ALARM
VO_046_59P_PKP
CONT OP OPER_F_02
VO_045_27P_PKP
CONT OP OPER_F_03 VO_048_50G_PKP
CONT OP OPER_F_04 VO_049_51G_PKP
VO_051_50PH_PKP
CONT OP OPER_F_05
VO_050_50PL_PKP
CONT OP OPER_F_06 VO_053_51P_PKP
OPERATION BIT 1
CONT OP OPER_F_07
AR CLOSE BREAKER
OPERATION BIT 2
CONT OP OPER_F_08
VO_083_GENERAL_TRIP
SETPOINT > RELAY CONFIGURATION > LEDS
LED SOURCE
LED01 VO_000_PROTECTION ALARM
LED02 VO_083_GENERAL_TRIP
LED03 VO_019_PHASE_OVERCURRENT_TRIP
LED04 VO_069_GROUND_OVERCURRENT_TRIP
VO_074_59P_TRIP
LED05
VO_073_27P_TRIP
LED06 VO_085_GENERAL_PKP
LED07 VO_007_PHASE_OVERCURRENT_PKP
LED08 VO_009_GROUND_OVERCURRENT_PKP
LED09 VO_045_27P_PKP
LED10 VO_046_59P_PKP
LED11 AR READY
LED12 AR RCL IN PROGRESS
LED13 AR BLOCK
LED14 AR CONDS INPUT
LED15 AR LOCKOUT
D-28
SOURCE LOGIC
-
-
-
-
SOURCE LOGIC
-
F650 DIGITAL BAY CONTROLLER
APPENDIX D:
LOGIC
-
-
-
-
-
-
-
-
LOGIC LED NAME
- PROT ALARM
- TRIP
- 50/51P TRIP
- 50/51G TRIP
- 27/59 TRIP
- PICKUP
- 50/51P PICKUP
- 50/51G PICKUP
- 27 PICKUP
- 59 PICKUP
- 79 READY
- 79 IN-PROG
- 79 BLOCK
NOT 79 INHIBIT
- 79 LOCKOUT
GEK-113000-AF