GE F650 User Manual page 165

CHAPTER 5: BOOTCODE AND FIRMWARE UPGRADE
3. This window only allows changing the last digit, which refers to supported communications protocols options. Click
Send:
4. The users must contact GE Multilin and provide the following parameters in their order:
– Unit serial number
– Current model option (before memory upgrade)
– Desired model option (after memory upgrade)
– Unit MAC address (available in the identification label)
5. Once the password is obtained, enter it when prompted.Tthe following messages appear if the password is correct.:
GEK-113000-AF
Figure 5-2: Set order code
Figure 5-3: Password requirement (special models)
F650 DIGITAL BAY CONTROLLER
5.2 FIRMWARE UPGRADE VERSION 7.00 OR ABOVE
5-27