GE F650 User Manual page 126

3.2 HUMAN-MACHINE INTERFACE (HMI)
next
<NEXT>
This option brings the system back to the one-line diagram.
<VIEW>
This option shows the real status of all inputs and outputs in the selected board. Depending on the type of board, with
or without supervision, the screen varies depending on the board characteristics.
The first line of this screen shows the slot where the board is located, F, G, H or J, and the type of board. The view
menu differentiates inputs and outputs; the active status (ON) is represented by the lighting of the corresponding
input or output.
The legend at the bottom of the screen indicates how to navigate:
Esc: Prev.
Esc: Prev.
Returns to the general I/O screen
Enter: Menu.
Provides access to the I/O menu (next, view, test input, test output).
: Chg Card
Pressing the up-down key or Moving the shuttle key to the left or right provides access to the status of inputs/
outputs for the different boards available in the relay.
<TEST INPUT>
This option allows testing the input activation (in emulation mode). The displayed screen is similar to the viewing
screen, but in this case the user can operate the different relay inputs.
This screen shows the Input name lit up, showing that this is an Input emulation mode.
The first relay input appears blinking and between brackets; the user can select a different input by pressing up-down
key or rotating the enter/shuttle key. When the shuttle key is pressed, the selected input is activated. Navigation
through this screen is indicated by the following legend:
3-64
IO Card F. Type: 2,
Input (ON OFF)
0 CC1 8 Va COIL1
1 CC2 9 Vb COIL1
2 CC3 10 Va COIL2
3 CC4 11 Vb COIL2
4 CC5 12 Isense1
5 CC6 13 Isense1
6 CC7 14 SUP21
7 CC8 15 SUP22
>VIEW<
Figure 3-38: Input/output viewing screen
Enter: Menu.
Esc: Exit Text.
F650 DIGITAL BAY CONTROLLER
CHAPTER 3: INTERFACES, SETTINGS & ACTUAL VALUES
# IN 8, # OUT 8
Output
test input test output
Enter: Chg Input.
: Chg Card
GEK-113000-AF