GE F650 User Manual page 162

5.2 FIRMWARE UPGRADE VERSION 7.00 OR ABOVE
3. Enter communication parameters for the relay being upgraded and click Upgrade.
If the IP address is incorrect one, the following message is shown:
4. If the IP address is correctly set, then the message "*.SFD Sending file" is displayed. A sending file status bar shows the
progress of the upgrade.
5. If the file is not sent successfully, the following message box is displayed.
5-24
Figure 5-1: Relay communication parameters
F650 DIGITAL BAY CONTROLLER
CHAPTER 5: BOOTCODE AND FIRMWARE UPGRADE
GEK-113000-AF