5.2 FIRMWARE UPGRADE VERSION 7.00 OR ABOVE
6.
After the successful operation, the SEND button is disabled. It is not allowed to make another change from here, so it
can be seen what changes have been made. The new order code appears on the status bar.
5.2.3 Summary of main firmware upgrade steps
1.
Install the proper version of the EnerVista 650 Setup software.
2.
Connect an Ethernet cable to the rear Ethernet port (a cross-over cable for back-to-back connection and straight-
5-28
Figure 5-4: Executed successfully
Figure 5-5: New order code
F650 DIGITAL BAY CONTROLLER
CHAPTER 5: BOOTCODE AND FIRMWARE UPGRADE
GEK-113000-AF