Table of Contents
Advertisement
4.3 TURNING OFF THE INSTRUMENT
The clamp-on meter can be turned off in two way.
■ Manually - Turn the switch to the OFF position.
■ Automatically - After ten min with no activity, the instrument will turn OFF.
Thirty (30) sec before the device is switched off, an audible signal sounds
intermittently. To re-activate the device, press any button or turn the rotary
switch.
4.4 CONFIGURATION
As a safety measure, and to avoid repeated overloads on the inputs of the
meter, configuration operations should only be performed when the meter is
disconnected from all dangerous voltages.
4.4.1 Auto Power Off
The Auto Power Off feature is enabled by default. To disable it, perform the
following:
1. In the OFF position, hold the
switch to
P
The
2. When the
function in the normal mode.
3. To return to Auto Power Off, turn the meter OFF and then back ON.
4.4.2 Current Threshold for True InRush
To configure the triggering current threshold of the True InRush
1. In the OFF position, hold the
switch to
The display will indicate the percentage overshoot to apply to the
measured current to determine the measurement triggering threshold.
The value stored by default is 10 %, representing 110 % of the
established current measured. The possible values are
(5, 10, 20, 50, 70, 100, 150 and 200) %.
2. To change the threshold, press the
each press on the
chosen threshold, apply a long press (> 2 sec) on the
confirmation beep is emitted.
To exit from the configuration mode, turn the switch to another setting. The
chosen threshold is stored and a double beep is emitted.
NOTE:
The starting (Inrush) current measurement triggering threshold
is fixed at 1 % of the least sensitive range.
This value is 1 % of 99.99 A or 1 A. This threshold is not adjustable.
26
until the full screen display ends and a beep is emitted.
symbol is displayed.
button is released, the device is in the voltmeter
until the full screen display ends and a beep is emitted.
button displays the next value. To record the
button down while turning the
Measurement
®
button down while turning the
button. The value flashes;
Clamp-On Meter Model 607 - User Manual
measurement:
®
button. A
Advertisement
Table of Contents
