Read Reference Gain Values - Basler A202K Manual

4.2.5.9 Read Reference Gain Values

Purpose:
Type:
Read Command:
Response:
Data Format:
k
BASLER A202
To read the reference gain values that are determined during the camera's factory
calibration procedure (see Section 3.5.2 for information on how to use these values).
This is a read only command.
Cmd-ID
0x08
Cmd-ID
0x08
Each reference value is stored as 16 bits followed by a decimal point followed
by 16 more bits.
Byte 1
Byte 2
Byte 3
Byte 4
Byte 5
Byte 6
Byte 7
Byte 8
Bytes 9 to 16
DRAFT
R/W-Flag Data Length
1
R/W-Flag Data Length
0
Low byte after the decimal point for the left side
reference gain value
High byte after the decimal point for the left side
reference gain value
Low byte before the decimal point for the left side
reference gain value
High byte before the decimal point for the left side
reference gain value
Low byte after the decimal point for the right side
reference gain value
High byte after the decimal point for the right side
reference gain value
Low byte before the decimal point for the right side
reference gain value
High byte before the decimal point for the right side
reference gain value
Reserved. Should be ignored.
Configuring the Camera
Data
16 -
Data
16 16 Bytes
4-23