Setup - Sharp JX-8200 Service Manual

SHARP SERVICE MANUAL JX8200SM [5] INSTALLATION
3) Remove the interface board from its packaging.
4) Hold the interface port on the interface board so that it is sticking
out of the slot for the optional interface and insert the interface
connector attached to the controller board into its socket on the
interface board.
NOTE: To remove the interface board, simply remove the interface
connector and remove the interface board. Then store it in
the anti-static bag that it came in for future use.
5) Using the screws removed in step 2, attach the interface board to
the back cover plate.

6. Setup

(1) Removing the Protective Covers and Pins in
the Printer
1) Open the front cabinet by depressing the front cabinet release
grips on both sides and pulling the cabinet towards you.
2) Open the top rear cover of the printer by pulling back the top rear
cover release button located on its right side. After releasing the
cover, raise it until it is vertical.
3) Grab the seals labeled
cover by pulling them in the direction of their arrows. Grab seal
and remove it by pulling it in the direction of its arrow.
b
5 – 5
a d
through and remove the protective
d
c
a
e
e