Table of Contents
Advertisement
SHARP SERVICE MANUAL JX8200SM [5] INSTALLATION
4. Packing List
Packing List
Printer
Floppy disk
• Printer driver for
PCL5EC
• Utility disk
• Macintosh
Color
Oil bottle (2 pieces)
toner cartridge
(Cyan, Magenta, and
Yellow)
Power cord
Drum cartridge
Developer
Developer
unit (Color)*
unit (Black)*
Waste toner box*
Ozone filter*
* These are shipped installed in the printer.
5. Installing Options
(1) Installation of the Secondary Feeder
1) Remove the secondary feeder from its box. Remove any protec-
tive tape and packaging materials.
Verify that all the parts in the following packing list are present.
Secondary feeder
Universal cassette
2) Place the secondary feeder on a sturdy, flat table.
3) Turn off the printer and remove all cables from the back of the
4) Have two people lift the printer by holding it at its bottom and lay
WARNING: The printer weighs 42 kg (93 pounds). Be careful when
Toner
cartridge (Black)
Fuser cleaner
5) Connect the connection cable from the back of the secondary
Universal cassette*
Fusing unit*
Operation manual
6) Remove the universal cassette from the secondary feeder and
7) Reconnect the power and interface cables and turn on the printer.
Instruction guide
5 – 3
printer including the power cable and computer interface cable.
the printer on top of the secondary feeder so that the two position-
ing pins fit into their holes that are located on the bottom of the
printer.
lifting the printer. It is very heavy and requires two
people to carry. Do not attempt to carry it by yourself or
allow anyone else to do so.
Positioning pins
feeder to the secondary feeder power connector on the back of
the printer.
load the paper.
After the printer warms up, the control panel will display PCL
LE/A4 (the on-line display will differ depending on the current
emulation setting and size of paper installed). This completes the
installation.
Advertisement
Table of Contents
