SHARP SERVICE MANUAL JX8200SM [8] ADJUSTMENTS
2
Set the jumper of flash memory on the source side as shown, and
insert into CN1.
Destination side
J401
J404
J401: 1-2
J404: 1-2
3
Set the jumper of flash memory on the destination side as shown,
and insert into CN2.
J401: 1-2
J404: 2-3
4
Connect one end of the IDT/Sim exclusive^use cable to CN5 of
the ICU board.
5
Connect the IDT/Sim exclusive-use cable to the 9-pin connector
(COM1) of the personal computer.
Source side
J402
J403
J402: 2-3
J403: 2-3
J402: 1-2
J403: 1-2
CN5
8 – 13
6
Start Windows.
7
Start the terminal software of Windows.
Perform setting of the host side serial port for communication with
the printer ICU PWB.
Incase of Windows3.1: Start the terminal in the accessory, and
open Idt.trm.
In case of Windows95: Open Idssim.ht in the hyper terminal in the
accessary.
Open the communication item in the setting menu and set the
parameters as shown below.