Process Sequence Window; Ratio Parameters Window; Blank Reagent Settings Window; Contamination Settings Window - Siemens ADVIA 1800 Operator's Manual

Process Sequence window*

CAUTION
Do not switch Process Sequence numbers
accumulated. Quality control data could be reported for the wrong tests. Patient
results are also affected.
Use this window to set the order in which:
• tests display at windows such as Order Entry, Test Select, and Real-Time QC
• tests print
Only tests set up in the windows listed below can be arranged at the Process Sequence
window:
• System Test List
• Analytical Parameters (Serum)
• ISE Parameter Settings
• Ratio Parameters

Ratio Parameters window*

Use this window to create up to 20 ratios with two test items in each. The ratio can contain
2 tests.

Blank Reagent Settings window**

You must log on as
Perform any of the following tasks at this window:
• assign a blank channel
• use the calibration sample from one test for another test

Contamination Settings window*

Use this window to set the conditions for preventing contamination of reagent probes and
reaction tray cuvettes.
Each condition specifies an action to be taken if a specific interferer contaminates a
specific receptor. You can set up to 100 conditions each for reagent probes and RRV
cuvettes.
Perform any of the following tasks at this window:
• set conditions for avoiding reagent probe contamination
• set conditions for avoiding RRV cuvette contamination
• set conditions for anti-contamination detergent
• print the conditions
• clear the conditions
66
service to access this window.
after control results have been
ADVIA 1800 Operator's Guide