Monitoring An Analysis While It Is Running; Processing Status; Sample Information And System Status - Siemens ADVIA 1800 Operator's Manual

Monitoring an analysis while it is running

1. At the Menu Panel, select
2. Monitor any of the following at this window:

• processing status

• sample information and system status

• result data information
When the run is completed, the operating mode display becomes END, then returns to
READY.
3. Close the window.
Processing status
The center of the window resembles the sample tray. The outer ring is the STT tray and
the inner ring is the CTT tray. Each tray position is a circle.
As the run continues, the circles containing samples change color. The colors indicate the
current status of each sample. The color codes are displayed at the lower-left of the
window.
For additional information about the color codes see page 42.
Sample information and system status
The button bar at the top of the window displays the Sample Search and Rack or LAS.
Sample Info. buttons.
•
Press the
sample information by sample number by STT position (tray number and sample
position), or by rack/LAS position (rack number and sample position).
The search returns a Sample Information window showing the sample number, position
number, sample status, and the time remaining to complete the analysis of the sample.
•
If a rack handler or laboratory automation system (LAS) is in use, select the
LAS. Sample Info.
LAS. Sample Information window:
♦
♦
♦
NOTE:
when you select the Rack or LAS. Sample Info. button, the system displays a message
that no sample information is available.
The left side of the Test Result Monitor window displays three panels.
•
The System Status panel shows the current operating mode of the system.
•
The Sample information panel shows the sample number and sample position of the
currently selected position on the STT/CTT graphic. If this is a barcode analysis, the
barcode number displays, and the position number is 0-00.
•
The code panel shows the color codes used in the STT/CTT graphic to represent
sample status.
90
Request
button to display a dialog box where you can search for
Sample Search
button to display the following sample information in the Rack or
Sample barcode number.
Sample status (see the status codes listed on the Test Result Monitor window).
The time remaining to complete the processing of the sample.
If processing has completed or if there are no samples available for processing
, then select
Test Result Monitor
ADVIA 1800 Operator's Guide
.
Rack or