1
Terminal 2
2
Joint Connector
3
Joint Holder
4
Phillips Screws (4 places)
Figure 5-29. Probe components
5. Cover the 12-volt LLS amplifier and wires with a lint-free paper towel.
6. Using the pliers, loosen the joint connector (
unfasten and remove it by hand.
7. Loosen but do
NOTE: Be careful not to drip any fluid from the probe onto the amplifier. If needed,
drain fluid into a container.
Maintenance
remove the 4 Phillips screws (
not
5
Probe
6
Terminal 1
7
Flange
) turning counterclockwise, then
2
).
4
161