Urgent Samples And Manual Reruns Are Run From The Onboard Sampler (Stt); Starting The Run; Running Calibrators And Reagent Baselines (Rbl) - Siemens ADVIA 1800 Operator's Manual

Urgent samples and manual reruns are run from the onboard sampler
(STT)
1. Verify that a workorder or rerun request exists for each STT sample.
2. At the Operation Panel, select
The operation mode changes to Pause Shift, then to Pause. A short delay may occur while
the analyzer changes operational states.
3. Load samples on the STT.
4. At the Operation Panel, select
5. Complete the Start Conditions window and start the run.
Make sure to select the
After aspirating the
racks are available, or it will enter the Watch mode while waiting for the next rack.

Starting the run

WARNING
1. In the Operation Panel, select
The Start Conditions window displays.
2. Perform any of the following tasks on this window:
• run calibrators and reagent baselines (RBL)
• run control samples
You cannot run multipoint calibrations, while you are running patient samples from the
STT tray.
Run patient samples:
• from the STT
• from the optional universal rack handler or external transport
3. To begin the run, select

Running calibrators and reagent baselines (RBL)

1. Select
number.
2. Select
You can select both calibration types.
3. Select
4. To remove any tests you do not want calibrated in this run, select
System Overview
Analyze box
samples, the system resumes sampling from the rack handler if
STT
If the system was stopped using the Emergency Stop button, you must perform a
Weekly wash (WASH2) prior to processing samples.
Start
Multipnt.smp. Analyze
One-pnt.smp. Analyze
. or
Ordinary calib Special calib
Pause .
.
Start
for the onboard sampler.
Start .
.
, then select
TT No. 98
.
.
or to select the STT tray
99
Temp.item select
.
87