Cleaning The Chiller Filter - Siemens ADVIA 1800 Operator's Manual

4. Remove the bottle.
5. Empty the remaining contents of the bottle.
6. Rinse the bottle with deionized water and drain well.
7. Refill the bottle with cuvette wash solution.
8. Return the bottle to the same position on the shelf in the cabinet.
9. Connect the cuvette wash bottle level sensor connector, then push the connector in
and turn it clockwise.
10. Insert the filter and hose, then fasten the cap.
NOTE:
11. Return the analyzer to the READY mode.
12. Prime the fluid lines:
NOTE:
a. Return the analyzer to the READY mode.
b. At the Operation Panel, select the
c. At the PRIME Settings dialog box, select
d. Select

Cleaning the chiller filter

Materials required:
• Vacuum cleaner
Time: 10 minutes
Analyzer mode: STANDBY
NOTE:
cabinet. It must be accessed through the panel door on the right side of the analyzer.
1. Set the analyzer to Standby.
2. On the front right side of the analyzer, push and release the panel door to gain access
to the chiller unit.
3. Locate the filter and slide it out of the analyzer.
4. Using a vacuum cleaner, remove the dust from the filter.
5. If the filter requires further cleaning, perform the following steps:
a. Wash the filter under running water.
b. Dry the filter before replacing it.
6. Slide the filter back in place and close the panel on the right side of the cabinet.
7. Return the analyzer to the READY mode.
Maintenance
CAUTION
Do not allow the level sensor connector to get wet. This may damage it.
Make sure that the filter holder is located at the bottom of the bottle.
If you are cleaning other bottles, wait to perform this step for all fluid lines.
the number of times in all fields.
Execute .
The chiller filter is located on the right inside bottom shelf of the analyzer
button.
Prime
Prime 2 and then type
BIOHAZARD
Wear personal protective equipment.
Use universal precautions.
10 or more for
143