Oracle Ilom Properties That Affect Post Behavior - Oracle SPARC T7-1 Service Manual

Configure POST
To set error_level, to max, and to set hw_change_level to max, type:
-> set /HOST/diag error_level=max
-> set /HOST/diag hw_change_level=max
Refer to the section on setting the SPARC host keyswitch state in the Oracle ILOM
Administrator's Guide for Configuration and Maintenance Firmware Release 3.2.x for a
description of parameters and values.
4. View the current values for settings.
For example:
-> show /HOST/diag
/HOST/diag
Targets:
Properties:
Commands:
->
Related Information
"POST Overview" on page 36
■
"Oracle ILOM Properties That Affect POST Behavior" on page 38
■
Oracle ILOM Properties That Affect POST
Behavior
There are a number of Oracle ILOM commands that you can use to perform host diagnostic
tests. For details about using these commands, refer to the chapter that describes configuring
38 SPARC T7-1 Server Service Manual • May 2017
default_level = off
default_verbosity = normal
error_level = max
error_verbosity = normal
hw_change_level = max
hw_change_verbosity = normal
cd
set
show