Attach Power Cords; Power On The Server (Oracle Ilom) - Oracle SPARC T7-1 Service Manual

Attach Power Cords

Related Information
"Remove the Server From the Rack" on page 54
■
"Attach Power Cords" on page 180
■
Attach Power Cords
1. Attach both power cords to the power supplies.
Note -
the server. Depending on how the firmware is configured, the server might boot at this time.
2. Power on the server.
See "Power On the Server (Oracle ILOM)" on page 180
Power Button)" on page
Related Information
"Power On the Server (Oracle ILOM)" on page 180
■
"Power On the Server (System Power Button)" on page 181
■

Power On the Server (Oracle ILOM)

Note -
by the top cover interlock switch, you must use the poweron command.
Type this command at the Oracle ILOM prompt.
-> poweron
You will see an alert message on the system console. This message indicates that the server is
reset. You will also see a message indicating that the VCORE has been margined up to the value
specified in the default .scr file that was previously configured. For example:
-> start /System
Related Information
"Power On the Server (System Power Button)" on page 181
■
"Clear a Fault Manually" on page 39
■
180 SPARC T7-1 Server Service Manual • May 2017
As soon as the power cords are connected to a power source, standby power is applied in
181.
If you are powering on the server following an emergency shutdown that was triggered
or "Power On the Server (System