Communication Detail Settings - Mitsubishi Electric GOT2000 Series Connection Manual

16.4.2

Communication detail settings

Make the settings according to the usage environment.
Item
Transmission Speed
*1
Data Bit
Stop Bit
Parity
Retry
Timeout Time
Delay Time
Control Method
*1 When using the hard copy function, set to 8bit.
POINT POINT POINT
(1) Communication interface setting by the Utility
(2) Precedence in communication settings
Description
Set this item when change the transmission speed used for
communication with printer.
(Default: 19200bps)
Set this item when change the data length used for communication with
printer.
(Default: 8bits)
Specify the stop bit length for communications.
(Default: 1bit)
Specify whether or not to perform a parity check, and how it is
performed during communication.
(Default: None)
Set the number of retries to be performed when a communication error
occurs.
(Default: 0times)
Set the time period for a communication to time out.
(Default: 30sec)
Set this item to adjust the transmission timing of the communication
request from the GOT.
(Default: 0ms)
Set this item when selecting the XON/XOFF control for the control
method.
(Default: XON/XOFF)
The communication interface setting can be changed on the Utility's [Communication setting]
after writing [Controller Setting] of project data.
For details on the Utility, refer to the following manual.
➠
GOT2000 Series User's Manual (Utility)
When settings are made by GT Designer3 or the Utility, the latest setting is effective.
Range
4800bps,
9600bps,
19200bps,
38400bps,
57600bps,
115200bps
7bits/8bits
1bit/2bits
None
Even
Odd
0 to 5times
3 to 90sec
0 to 300ms
XON/XOFF
None
16.4 GOT Side Settings
16
16 - 7