Mitsubishi Electric GOT2000 Series Connection Manual page 406

18.3.2 Communication detail settings
Item
Set this item when change the transmission speed used for communication with the connected
Transmission Speed equipment.
(Default: 9600bps)
Set this item when change the data length used for communication with the connected
Data Bit equipment.
(Default: 8bits)
Specify the stop bit length for communications.
Stop Bit
(Default: 1bit)
Specify whether or not to perform a parity check, and how it is performed during communication.
Parity
(Default: Even)
Set whether or not to perform a sum check during communication.
Sum Check
(Default: Done)
Set the number of retries to be performed when a communication timeout occurs.
Retry
When receiving no response after retries, the communication times out. (Default: 0time)
Set the time period for a communication to time out.
Timeout Time
(Default: 3sec)
Set this item to adjust the transmission timing of the communication request from the GOT.
Delay Time
(Default: 0ms)
Select the communication format.
(Default: 15)
Dedicated protocol
• Format 10 (LS Industrial Systems Co., Ltd. LSR)
Format
• Format 11 (MARS TOHKEN SOLUTION CO.LTD. ICU-60S)
• Format 12
Nonprocedural protocol
• Format 15
*1
18 - 6
18.3 GOT Side Settings
*1
(MARS TOHKEN SOLUTION CO.LTD. ICU-215 (Mifare))
GT21 does not support Format 12.
POINT POINT POINT
(1) Communication interface setting by the Utility
The communication interface setting can be changed on the Utility's [Communication setting]
after writing [Controller Setting] of project data.
For details on the Utility, refer to the following manuals.
➠
User's Manual of GOT used.
(2) Precedence in communication settings
When settings are made by GT Designer3 or the Utility, the latest setting is effective.
Description Range
4800bps, 9600bps, 19200bps,
38400bps, 57600bps,
115200bps
7bits/8bits
1bit/2bits
None
Even
Odd
Yes or No
0 to 5times
3 to 30sec
0 to 3000ms
10/11/12/15