Mitsubishi Electric GOT2000 Series Connection Manual page 337

*1 For connectable bar code readers, system equipment, available bar code types and connection cables, refer to the following
Technical News.
➠
List of valid devices applicable for GOT2000 series (GOT-A-0064)
*2 When a GT10-C02H-6PT9P unit of the sub version A or B is used, do not ground the case of the D-sub (9-pin) connector.
POINT POINT POINT
When using the RS-232 communication unit
Use the RS-232 communication unit of the GOT for connecting to a barcode reader.
However, when the RS-232 communication unit is used, the power cannot be supplied to a bar
code reader from the GOT.
POINT POINT POINT
System configuration between the GOT and PLC
For the system configuration between the GOT and PLC, refer to each chapter.
➠ Mitsubishi Products
➠ Non-Mitsubishi Products 1, Non-Mitsubishi Products 2
➠
Microcomputer, MODBUS Products, Peripherals
11.2 System Configuration
11
11 - 3