Mitsubishi Electric GOT2000 Series Connection Manual page 147

POINT POINT POINT
(1) Special Interrupt Code
The following shows the compatibility between the special interrupt codes and the event
types.
Special Interrupt Code
(Hex)
Base Screen
Output when the screens are switched according to the change in the switching device
values assigned to 1/2.
20H
*1:Base Screen or Overlap Window 1/2 switches independently without being interlocked.
(Example of output)
When all the switching device values assigned to the Base Screen and Overlap
Window1/2 are changed, 3 special interrupt codes are output.
21H Output when Numerical/ASCII Input is completed.
22H Output when Recipe data transfer (read-out, write-in) is completed.
23H Output when Bar code, RFID data has been imported into GOT
(2) Communication detail setting when connecting multiple GOTs
For the following items, set the same settings to the n+1th GOT interface as the CH No.1 of
n-th GOT.
• Transmission Speed
• Data Bit
• Stop Bit
• Parity
Set each [Host Address] for the GOT.
(3) Communication interface setting by the Utility
The communication interface setting can be changed on the Utility's [Communication setting]
after writing [Controller Setting] of project data.
For details on the Utility, refer to the following manual.
➠
User's Manual of GOT used.
(4) Precedence in communication settings
When settings are made by GT Designer3 or the Utility, the latest setting is effective.
Event type
*1 *1
and Overlap Window
2.6 GOT Side Settings
2
2 - 85