Filter And Jib Lights - Henny Penny LVE-102 Technical Manual

7-20. FILTER AND JIB LIGHTS

Sept. 2008
Replacement:
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit
breaker, or unplug cord at wall receptacle.
1. Remove control panel.
2. Locate wires to light and cut wires.
3. Using a 13/16", deep-well socket (see photo at left) remove
nut on the back side of the panel and pull the light from
front of the panel.
4. Install new light with deep-well socket, connect wires with
wire nuts and reinstall the control panel.
5. Restore power to the unit.
7-23
Model LVE-102, 103, 104