Control Board Transformer; Circuit Breakers - Henny Penny CFE-410 Technical Manual

3-10. CONTROL BOARD
TRANSFORMER

3-11. CIRCUIT BREAKERS

Jan. 2013
1. Remove electrical power supplied to fryer.
To avoid electrical shock or property damage, move
the POWER switch to OFF and disconnect main
circuit breaker, or unplug cord at wall receptacle.
2. Open the control panel and locate the "CONTROL
TRANSFORMER" connectors and disconnect from the
control board.
3. Using a phillips head screwdriver, remove the 2 screws
securing the transformer.
4. Install the new transformer in reverse order.
1. Remove electrical power supplied to fryer.
To avoid electrical shock or property damage, move
the POWER switch to OFF and disconnect main
circuit breaker, or unplug cord at wall receptacle.
2. Remove the control panel as discussed in Complete Control
Panel Replacement Section.
3. Lable and remove wires from the old circuit breaker.
4. Loosen the nut securing the breaker from underneath with
a 9/16 in. wrench and then pull the old breaker from the
control panel area.
5. Install new circuit breaker in reverse order.
3-9