Friendly Robotics robomower RL350 Service Manual page 87

3.2.10 Wire Sensors Problems (con.)
3.2.10.2
'Move from
wire'
message
Were the Main
YES
Board or Wire
Sensors
replaced?
NO
On the
wire or
very close
Where is
to it
the
Robomower
positioned?
Well inside
the lawn
Move the Robomow
10ft/3m from its
place and retry
Test the wire sensors
readings (section
5.3.5) and refer to
fault code (see table
in section 5.6)
Position the mower
inside an active plot
and perform 'Learn
wire sensors' (refer
to section 5.3.1)
Move the Robomow at
least 3ft/1m from the
wire and retry
Replace Wire Sensors (SPP0018A)
Replace Main Board (SPP0019B) and
complete the following settings
(under the 'Service' menu):
- 'Factory default' (Section 5.5.6)
- 'Learn wire sensors' (Section 5.3.1)
- 'Edge Calibration (Section 5.3.2)
- 'Set country' (Section 5.3.3)
- 'DK Calibration' (Section 5.3.4)
3
32