Friendly Robotics robomower RL350 Service Manual page 76

3.2.5 Automatic Mowing Problems (con.)
If the Manual Controller
cord is misplaced in the
cavity it may push the
Manual Controller during
operation and stop the
automatic operation
The display is turned off
automatically after 20 min.
Remove the Manual
Controller from its place or
press the GO button to see
the last message displayed
Confirm The Manual Controller
is placed well and flushed with
the Top Cover.
Confirm Power Pack contacts on
both sides (bat. and RL) are not
loose/damaged.
Remove Connectors Board
cover and confirm the fuses are
not free to move and there is
no corrosion on the fuse
housing.
Confirm good contact between
M. Controller cord plug and
socket on the Connector Board.
Remove Power Pack cover and
check for loose connections
3.2.5.3
Robomow had
stopped and is
found with no error
message
Blank
What was
LCD
the display
in the LCD?
Zone A /
Dock zone
Is it a
YES
recurring
problem?
NO
Confirm the Manual Controller
is placed well and flushed with
the Top Cover – short lifting of
the Manual Controller while
operating will cause the mower
to stop.
Robomower is like a computer
– in very rare cases it may
shutdown automatically (reset)
A magnet is located
underneath the
rectangular
protrusion. Its
function is to change
between the Manual
and the Auto modes
Make sure that prior to
inserting the Manual
Controller to its place,
the cord is stored well
Manual
User Option
Replace the M. Controller
with a good one and view
the display to see if it
changes to Auto menu
when it is flushed with the
NO
Remove the Top
cover – confirm
there is a magnet
inside the cover
underneath.
NO
Is the M.
Controller in its
place (flushed
with the Top
Cover surface)?
YES
Top Cover
Is it
YES
changed?
The Manual
Controller is
faulty -
Replace
3
21