Lists Of Commands - Agilent Technologies 86120C User Manual

Lists of Commands

Table 3-10. Programming Commands (1 of 5)
Command
Codes: S indicates a standard SCPI command. I indicates an instrument specific command.
Common Commands
*CLS
*ESE
*ESR?
*IDN?
*OPC
*RCL
*RST
*SAV
*SRE
*STB
*TRG
*TST?
*WAI
Measurement Instructions
:CONFigure
:FETCh
:MEASure
:READ
Description
Clears all event registers and the error queue.
Sets the bits in the standard-event status enable register.
Queries value standard-event status register.
Queries instrument model number and firmware version.
Sets operation complete bit of the standard-event status register.
Recalls a saved instrument state.
Resets instrument.
Saves an instrument state.
Sets bits in service-request enable register.
Queries value of status byte.
Triggers acquisition of measurement data.
Performs an instrument self test.
Causes instrument to finish processing current command before
continuing.
Configures instrument for wavelength, wavenumber,
frequency, power, and measurements.
Queries wavelength, wavenumber, frequency, power, and
measurements that have already been captured.
Configures, measures, and queries wavelength,
wavenumber, frequency, power, and measurements.
Measures and queries wavelength, wavenumber,
frequency, power, and measurements.
Programming
Lists of Commands
Code
I
I
I
I
3-43