Table of Contents
Advertisement
Programming
Making Measurements
After collecting the uncorrected data, the Agilent 86120C searches the
data for the first 200 peak responses. (For WLIMit:OFF, searching
starts at 1650 nm and progresses towards 1270 nm. For WLIMit:ON,
searching starts at WLIMit:START and progresses toward
WLIMit:STOP.) These peak values are then placed into the corrected
data buffer. Each peak value consists of an amplitude and wavelength
measurement. Amplitude and wavelength correction factors are applied
to this data.
For a listing of the programming commands (including a cross refer-
ence to front- panel keys), refer to the following tables:
Table 3- 10, "Programming Commands," on page 3- 43
Table 3- 11, "Keys Versus Commands," on page 3- 48
3-6
Advertisement
Table of Contents
