Table of Contents
Advertisement
Programming
Lists of Commands
Table 3-10. Programming Commands (2 of 5)
Command
Codes: S indicates a standard SCPI command. I indicates an instrument specific command.
CALCulate1 (CALC1) Subsystem
:CALCulate1:DATA?
:CALCulate1:TRANsform:FREQuency:POINts?
CALCulate2 (CALC2) Subsystem
:CALCulate2:DATA?
:CALCulate2:PEXCursion
:CALCulate2:POINts?
:CALCulate2:PTHReshold
:CALCulate2:PWAVerage[:STATe]?
:CALCulate2:WLIMit[:STATe]
:CALCulate2:WLIMit:STARt:FREQuency
:CALCulate2:WLIMit:STARt[:WAVelength]
:CALCulate2:WLIMit:STARt:WNUMber
:CALCulate2:WLIMit:STOP:FREQuency
:CALCulate2:WLIMit:STOP[:WAVelength]
:CALCulate2:WLIMit:STOP:WNUMber
CALCulate3 (CALC3) Subsystem
:CALCulate3:ASNR:CLEar
:CALCulate3:ASNR:COUNt
:CALCulate3:ASNR:[:STATe]
:CALCulate3:DATA?
:CALCulate3:DELTa:POWer[:STATe]
:CALCulate3:DELTa:REFerence:FREQuency
:CALCulate3:DELTa:REFerence:POWer?
3-44
Description
Queries the uncorrected frequency-spectrum data of the
input signal.
Sets and queries the number of points in the data set.
Queries the corrected frequency-spectrum data of the
input signal.
Sets the peak excursion limit.
Queries the number of points in the data set.
Sets the peak threshold limit.
Places the instrument in the average-wavelength mode.
Data queries return the power-weighted average
frequency, wavelength, or wavenumber or total power.
Turns wavelength limiting on and off.
Sets the starting frequency for the wavelength limit range.
Sets the starting wavelength for the wavelength limit
range.
Sets the starting wavenumber for the wavelength limit
range.
Sets the stopping frequency for the wavelength limit
range.
Sets the stopping wavelength for the wavelength limit
range.
Sets the stopping wavenumber for the wavelength limit
range.
Resets and restarts the signal-to-noise ratio averaging.
Sets the number of measurements to average the signal-
to-noise ratio.
Turns signal-to-noise ratio averaging mode on and off.
Queries the data resulting from delta, drift, and signal-to-
noise measurements.
Turns the delta power measurement mode on and off.
Selects the signal to be used as the reference for the
DELTa calculations.
Queries the power level of the reference signal.
Code
S
S
S
I
I
I
I
I
I
I
I
I
I
I
I
I
I
S
I
I
I
Advertisement
Table of Contents
