Table of Contents
Advertisement
Programming Commands
CALCulate3 Subsystem
DRIFt:DIFFerence[:STATe]
Sets the drift calculation to subtract the minimum values measured
from the maximum values measured.
Syntax
:CALCulate3:DRIFt:DIFFerence[:STATe]{?| {ON | OFF | 1 | 0}}
Attribute
Preset State: off
Summary
*RST State: off
SCPI Compliance: instrument specific
Description
Use the CALC3:DRIF:PRES command to turn off all the drift states
before turning on this state. The CALC3:DATA? query returns the max-
imum power and frequency minus the minimum power and frequency.
4-56
Note
Only one STATe command can be turned on at any one time. Attempting to turn
more than one state on at a time results in a "–221 Settings Conflict" error.
to "Measure delta, drift, and signal-to-noise" on page 3-14
tion on selecting measurements.
Refer
for additional informa-
Advertisement
Table of Contents
