Lists Of Commands - Agilent Technologies Agilent 86120B User Manual

Table 4-7. Programming Commands (1 of 4)
Command
Codes: S indicates a standard SCPI command. I indicates an instrument specific command.
Common Commands
*CLS
*ESE
*ESR?
*IDN?
*OPC
*RCL
*RST
*SAV
*SRE
*STB
*TRG
*TST?
*WAI
Measurement Instructions
:CONFigure
:FETCh
:MEASure
:READ

Lists of Commands

Description
Clears all event registers and the error queue.
Sets the bits in the standard-event status enable register
Queries value standard-event status register.
Queries instrument model number and firmware version.
Sets operation complete bit of the standard-event status register
Recalls a saved instrument state.
Resets instrument.
Saves an instrument state.
Sets bits in service-request enable register
Queries value of status byte
Triggers acquisition of measurement data.
Performs an instrument self test
Causes instrument to finish processing current command before
continuing.
Configures instrument for wavelength, wavenumber, frequency,
power, and coherence length measurements.
Queries wavelength, wavenumber, frequency, power, and
coherence length measurements that have already been
captured.
Configures, measures, and queries wavelength, wavenumber,
frequency, power, and coherence length measurements.
Measures and queries wavelength, wavenumber, frequency,
power, and coherence length measurements.
Programming
Lists of Commands
Code
I
I
I
I
4-43