Agilent Technologies 86120C User Manual page 228

Programming Commands
SYSTem Subsystem
PRESet
Performs the equivalent of pressing the front- panel PRESET key.
Syntax
:SYSTem:PRESet
Preset State: none
Attribute
Summary *RST State: none
SCPI Compliance: standard
Command Only
Description The instrument state is set according to the settings shown in the fol-
lowing table.
Table 4-19. Instrument Conditions (1 of 2)
4-100
Item
Display mode
Wavelength range limiting
Start wavelength
Stop wavelength
Graphical display
Measurement acquisition
Wavelength calibration
Elevation correction value
Wavelength units
Amplitude units
Power offset
Peak threshold
Peak excursion
Settings after Preset Settings after Power
Key Pressed Turned On
single wavelength
last state
on last state
1270 nm last state
1650 nm last state
off off
continuous last state
vacuum last state
not affected last state
nm last state
dBm last state
0 dB last state
10 dB last state
15 dB last state
a