Table of Contents
Advertisement
Instrument states
Four different instrument states can be saved and recalled at a later
time. The actual instrument conditions that are saved are identical to
those saved from the previous state after power is turned on. These
conditions are shown in
or an application (such as signal- to- noise) is on when an instrument
state is saved, it is off when that state is recalled.
To save an instrument state
1 Press the Setup key.
2 Press the SAV/RCL softkey.
3 Press the SAVE softkey.
4 Press one of the four SAVE softkeys to save the instrument state.
To recall an instrument state
1 Press the Setup key.
2 Press the SAV/RCL softkey.
3 Press the RECALL softkey.
4 Press one of the four RCL softkeys to recall an instrument state.
Power bar
To control the power bar
1 Press the Setup key.
2 Press MORE twice, and then PWR BAR.
3 Press BAR ON to display the power bar, and press BAR OFF to hide the
power bar display.
Measuring Wavelength and Power
Table 5- 22 on page 7-
Making Measurements
2. If drift measurements
2-11
Advertisement
Table of Contents
