Table of Contents
Advertisement
Table 3-10. Programming Commands (5 of 5)
Command
Codes: S indicates a standard SCPI command. I indicates an instrument specific command.
:SENSe:CORRection:ELEVation
:SENSe:CORRection:OFFSet:MAGNitude
:SENSe:CORRection:MEDium
:SENSe:DATA?
STATus Subsystem
:STATus:{OPERation | QUEStionable}:CONDitio
n?
:STATus:{OPERation | QUEStionable}:EVENt?
:STATus:{OPERation | QUEStionable}:ENABle
:STATus:{OPERation | QUEStionable}:PTRansit
ion
:STATus:{OPERation | QUEStionable}:NTRansit
ion
:STATus:PRESet
SYSTem Subsystem
:SYSTem:ERRor?
:SYSTem:HELP:HEADers?
:SYSTem:PRESet
:SYSTem:VERSion
TRIGger Subsystem
:ABORt
:INITiate:IMMediate
:INITiate:CONTinuous
UNIT Subsystem
:UNIT[:POWer]
Description
Sets the elevation value used by the instrument to
compensate for air dispersion.
Sets the power offset value used by the instrument.
Sets the instrument to return the wavelength reading in a
vacuum when the parameter is on. Parameters are VAC
and AIR.
Queries the time domain samples of the input signal.
Returns the value for the condition register for the node.
Returns the value of the event register for the node.
Sets the enable register.
Sets the positive transition filter register.
Sets the negative transition filter register.
Presets the enable registers for all status nodes.
Queries an error from the error queue.
Queries an ASCII listing of all Agilent 86120C remote
commands.
Performs the equivalent of a front-panel PRESET key
press.
Queries the version of SCPI with which this instrument is
compliant.
Stops the current measurement sequence.
Places the instrument into the initiated state and initiates
a new measurement sequence.
Sets the instrument for single or continuous
measurement.
Sets the power units to watts (linear) or dBm (logarithmic).
Programming
Lists of Commands
Code
I
S
I
I
S
S
S
S
S
S
S
I
S
S
S
S
S
S
3-47
Advertisement
Table of Contents
