WSB-PV-D4251/D5251 SBC
Step 3:
The recovery tool setup menu is shown as below.
Figure B-3: Recovery Tool Setup Menu
Step 4:
Press <5> then <Enter>.
Figure B-4: Command Mode
Step 5:
The command prompt window appears. Type the following commands (marked
in red) to create two partitions. One is for the OS installation; the other is for
saving recovery files and images which will be an invisible partition.
(Press <Enter> after entering each line below)
system32>diskpart
DISKPART>list vol
DISKPART>sel disk 0
DISKPART>create part pri size=
DISKPART>assign letter=N
DISKPART>create part pri size=
DISKPART>assign letter=F
DISKPART>exit
system32>format N: /fs:ntfs /q /y
___
___
Page 95