So-Dimm Installation; Figure 4-1: So-Dimm Installation - IEI Technology WSB-PV-D4251 User Manual

Before and during the installation of the WSB-PV-D4251/D5251 DO NOT:
DO NOT remove any of the stickers on the PCB board. These stickers are
required for warranty validation.
DO NOT use the product before verifying all the cables and power connectors
are properly connected.
DO NOT allow screws to come in contact with the PCB circuit, connector pins,
or its components.

4.3 SO-DIMM Installation

To install a SO-DIMM, please follow the steps below and refer to Error! Reference source
not found..

Figure 4-1: SO-DIMM Installation

Step 1: Open the SO-DIMM socket handles. Open the two handles outwards as far as
they can. See Error! Reference source not found..
Step 2: Align the SO-DIMM with the socket. Align the DIMM so the notch on the
memory lines up with the notch on the memory socket. See Error! Reference
source not found..
Step 3: Insert the SO-DIMM. Once aligned, press down until the SO-DIMM is properly
seated. Clip the two handles into place. See Error! Reference source not found..
Page 38
WSB-PV-D4251/D5251 SBC