Jumper Settings; Clear Cmos Jumper; Table 4-1: Jumpers - IEI Technology WSB-PV-D4251 User Manual

4.5 Jumper Settings

NOTE:
A jumper is a metal bridge that is used
to close an electrical circuit. It consists
of two metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them.
To CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper means removing the plastic clip
from a jumper.
Before the WSB-PV-D4251/D5251 is installed in the system, the jumpers must be set in
accordance with the desired configuration. The jumpers on the WSB-PV-D4251/D5251
are listed in Table 4-1.
Description
Clear CMOS setting
CF Card setting
LCD Panel Resolution setting
LCD Voltage Select setting

Table 4-1: Jumpers

4.5.1 Clear CMOS Jumper

Jumper Label:
Jumper Type:
Jumper Settings:
Jumper Location:
Page 40
J_CMOS1
2-pin header
See Table 4-2
See Figure 4-3
WSB-PV-D4251/D5251 SBC
Label Type
J_CMOS1 2-pin header
JCF1 3-pin header
J_LCD_TYPE1 8-pin header
J_VLVDS1 3-pin header