Motion Device Selection - Newport MM4006 Manual

MM4006
H O M E
2.2.2.2
H O M E
EDH0181En1020 — 03/03
need to correct the entry, use the
you changed your mind, exit by pressing the
JOG
AXES
1 2 3
1/5
Axis Setup
1 : - 3 . 3 5 6 m m 4 5 6
2/6
2 : 1 2 . 3 4 5 D e g
3 : 2 . 3 4 5 6 m m
7 8 9
4 : U n c o n n e c t e d
3/7
S e l e c t a c t i o n
- .
M A N U A L M O V E P R O G . 0
4/8

Motion Device Selection

One of the advanced features of the MM4006 controller is that it has stored
in its firmware all necessary parameters for all compatible motion devices
supplied by Newport.
To avoid scrolling through over 100 components, the selection is made in
two steps, first the family and then the component model.
From the top-level Axes Setup menu press the
screen to change the Product Family. A family represents a group of motion
devices with the same prefix. Use the
family list. When the desired product family is displayed, press the
key to accept the entry and advance to the next menu, the model selection.
Notice that the first product family displayed is DEFAULT. This is to
allows the user to define the parameters of a custom device or one that is
not manufactured by Newport.
Once a family is selected, the controller prompts you to pick a product
model from the selected family. Use the
the model list. When the desired product model is displayed, press the
VALID
Pressing the
Axes Setup menu.
Part of the component selection procedure is setting the PID parameters.
It is strongly recommended that these parameters should not be changed
from this menu. They are displayed here only for factory setup purposes.
After a component model has been selected, the next menu displays the Kp
parameter. Do not make any changes to the value; press
same for the following Ki and Kd parameters. This will return the display to
the top level Axes Setup menu.
JOG
AXES
1 2 3
1/5
4 5 6
1 : - 3 . 3 5 6 m m
Axis Setup
2 : 1 2 . 3 4 5 2/6 D e g
3 : 2 . 3 4 5 6 m m
7 8 9
4 : U n c o n n e c t e d
3/7
S e l e c t a c t i o n
- 0 .
M A N U A L M O V E P R O G .
4/8
VALID
SF — Set motion device.
AXES
1
1/5
→ →
AXIS #
4
2/6
7
3/7
-
4/8
key to accept the entry and advance to the next menu.
function key will return the display to the top level
QUIT
→ →
SELECT UP
→
VALID
2.18
key to erase the number or, if
DELETE
key.
QUIT
JOG
2 3
→
VALID
5 6
8 9
.
0
key. This activates a
SELECT
or
UP DOWN
NOTE
or
UP DOWN
NOTE
→ →
VALID UP
Local Mode
keys to scroll the
VALID
keys to scroll
. Do the
VALID
→ →
VALID