Maximum Speed; Scaling Speed - Newport MM4006 Manual

MM4006
2.2.2.20
H O M E
2.2.2.21
H O M E

Maximum Speed

This is the maximum velocity allowed for a given motion device. No pro-
gramed velocities are allowed to exceed this value. It also represents the
default velocity if no other value has been set previously (by a remote com-
mand). It can be changed by the user but it should never exceed the default
value. Use the Speed Scaling parameter instead to temporarily reduce the
motion velocities.
If you are setting up a new motion device that has no default parameters
and have defined the scaling speed, press the
Maximum speed. Use the numeric keypad to enter a value that is about 80%
of the scaling speed. Press
the previous menu.
Press the
JOG
AXES
1 2 3
1/5
1 : - 3 . 3 5 6 m m 4 5 6
Axis Setup
2/6
2 : 1 2 . 3 4 5 D e g
3 : 2 . 3 4 5 6 m m
7 8 9
4 : U n c o n n e c t e d
3/7
S e l e c t a c t i o n
- .
M A N U A L M O V E P R O G . 0
4/8
QUIT
VA — Set velocity.

Scaling Speed

Scaling speed is a hardware calibration parameter and is not intended to be
used by the operator. It represents the approximate velocity the motion
device will move if the maximum control voltage is sent to the driver (DC
motor case). In other words, it is the velocity for a saturated DAC. It is a
hardware calibration factor and the default value should not be modified.
For stepper motors it has a similar meaning but represents the stage veloci-
ty corresponding to the maximum acceptable motor speed.
If you need to set up a non-standard motion device that has no default para-
meters, after determining the correct value (motion control expertise is
required), press the
keypad to enter the correct value. Press
and return to the previous menu.
Press the
JOG
AXES
1 2 3
1/5
1 : - 3 . 3 5 6 m m 4 5 6
Axis Setup
2/6
2 : 1 2 . 3 4 5 D e g
2 . 3 4 5 6 m m
3 :
7 8 9
4 : U n c o n n e c t e d
3/7
S e l e c t a c t i o n
.
M A N U A L M O V E - P R O G . 0
4/8
QUIT
VALID
key to advance to the next parameter.
UP
→ →
MODIFY UP
→ → →
QUIT YES
key to set the scaling speed. Use the numeric
MODIFY
key to advance to the next parameter.
UP
→ →
MODIFY UP
→ → →
QUIT YES
2.27
MODIFY
to accept the new setting and return to
JOG
AXES
1 2 3
→ → 1/5 →
MODIFY 4 5 6
2/6
7 8 9
3/7
.
- 0
4/8
QUIT
to accept the new setting
VALID
JOG
AXES
1 2 3
→ → →
1/5
MODIFY 4 5 6
2/6
7 8 9
3/7
.
- 0
4/8
QUIT
Local Mode
key to set the
→
VALID
→
VALID
EDH0181En1020 — 03/03