Home Preset; Maximum Position - Newport MM4006 Manual

MM4006
2.2.2.12
H O M E
2.2.2.13
H O M E

HOME Preset

This feature is used to set the zero location according to the application's
needs. This parameter defines the value that will be loaded into the posi-
tion register when the motion device's home is found. The factory default
is zero, meaning that at the home location the position is zero. If, for
instance, this parameter is set to 12.3 mm, at the home location the con-
troller reports position 12.3 mm.
Do not set a value for the HOME Preset parameter that is outside the soft-
ware travel limits.
To change the HOME Preset parameter, press the
numeric keypad to enter a new value and then press
setting and return to the previous menu.
Press the
JOG
AXES
1 2 3
1/5
- 3 . 3 5 6 m m 4 5 6
1 :
Axis Setup
2/6
2 : 1 2 . 3 4 5 D e g
3 : 2 . 3 4 5 6 m m
7 8 9
4 : U n c o n n e c t e d
3/7
S e l e c t a c t i o n
.
M A N U A L M O V E - P R O G . 0
4/8
QUIT
SH — Set home preset position.

Maximum Position

This parameter defines the positive (usually right) software travel limit. No
motion will be allowed to exceed this position in the positive direction.
Do not set a higher value for this than the default value, otherwise the
hardware limit switch will be tripped.
To change the positive software travel limit, press the
numeric keypad to enter a new value and then press
setting and return to the previous menu.
Press the
JOG
AXES
1 2 3
1/5
1 : - 3 . 3 5 6 m m 4 5 6
Axis Setup
2/6
2 : 1 2 . 3 4 5 D e g
3 : 2 . 3 4 5 6 m m
7 8 9
4 : U n c o n n e c t e d
3/7
S e l e c t a c t i o n
- .
M A N U A L M O V E P R O G . 0
4/8
QUIT
SR — Set right travel limit.
key to advance to the next parameter.
UP
→ →
MODIFY UP
→ → →
QUIT YES
key to advance to the next parameter.
UP
→ →
MODIFY UP
→ → →
QUIT YES
2.23
MODIFY
VALID
JOG
AXES
1 2 3
→ →
1/5
MODIFY 4 5 6
2/6
7 8 9
3/7
- 0 .
4/8
QUIT
CAUTION
MODIFY
VALID
JOG
AXES
1 2 3
→ → 1/5
MODIFY 4 5 6
2/6
7 8 9
3/7
.
- 0
4/8
QUIT
Local Mode
key. Use the
to accept the
→ →
VALID
key. Use the
to accept the
→ →
VALID
EDH0181En1020 — 03/03