Operating In Blind Front Panel; Dip Switches To Configure The Communication - Newport MM4006 Manual

MM4006
2.5

Operating in Blind Front Panel

EDH0181En1020 — 03/03
program. The new line is inserted before the first line currently displayed.
When the
menu. Following the descriptions in the Command Line Creation para-
graph, create a new command line and, when done, press the key to termi-
nate it and return to the Program Editing menu.
Delete a program line.
DELETE
Program lines cannot be edited. They can only be erased and new ones cre-
ated.
To delete a program line, use the
keys to scroll through the listing until the line to be deleted is the first one
on the display. Pressing the
returns to the Program Editing menu.
When all the modifications have been made, press the
controller will ask if you want to save the changes. Press the
accept the modifications and return to the Program menu.
2.5.1

Dip Switches to Configure the Communication

A window in the front panel give access to twelve slide dip switches, these
dip switches are used to configure the communication setup of the con-
troller. These dip switches must be set accordingly to the communication
parameters you want to use to enable your computer to communicate with
the controller. The following tables will help you to properly setup these
switches.
STAND-BY
MOTOR
OFF
ON
The controller only reads these switches at its initialization. So, to change
the configuration you should switch the controller MOTOR
BY) make the new switches setup and switch the controller MOTOR
key is selected, the controller activates the Line Entry
INSERT
DELETE
Motion Controller
Model MM4006
1 2 3 4 5 6 7 8
EOR +
EOR -
ON
OFF
2.48
, ,
UP DOWN FIRST
key will erase the line and the display
1 2 3 4 5 6 7 8
Local Mode
, and
LAST
key. The
QUIT
key to
YES
9 10 11 12
(STAND-
OFF
.
ON