Display Color Selection Menu; Figure 3.13 Flow Chart For Display Color Selection - Newport i Series Operator's Manual

3.2.14 DISPLAY COLOR SELECTION
This submenu allows the user to select the color of the upper display.

Figure 3.13 Flow Chart for Display Color Selection

ENTER DISPLAY COLOR SELECTION MENU:
Press a
Press d
Press a
Press d
NORMAL COLOR DISPLAY SUBMENU:
Press d
Press b
Press d
The menu below allows the user to change the color of the upper display when
Alarm 1 is triggered.
ALARM 1 DISPLAY COLOR SUBMENU:
Press d
Press b
Press d
A color change is based on the Relative Humidity value only.
If this value causes an alarm condition, the upper display will change to
the selected Alarm 1 Color. A color change will occur whether Alarm 1 is
enabled or disabled.
1) Press a , if necessary, until CNFG prompt appears.
2) Display advances to RDG Reading Configuration Menu.
3) Press a , if necessary, until Display advances to COLR

Display Color Selection Menu.

4) Display advances to N.CLR Normal Color Submenu.
5) Display flashes the previous selection for "Normal Color".
6) Scroll through the available selections: GRN , RED or AMBR .
7) Display shows STRD stored message momentarily and then
advances to 1.CLR only, if it was changed, otherwise press a to
advance to 1.CLR Alarm 1 Display Color Submenu.
8) Display flashes previous selection for "Alarm 1 Color
Display".
9) Scroll through the available selections: GRN , RED or AMBR .
10) Display shows STRD stored message momentarily and then
advances to 2.CLR only, if it was changed, otherwise press a to
advance to 2.CLR Alarm 2 Display Color Submenu.
46