Related Manuals for Newport MM4006
Summary of Contents for Newport MM4006
- Page 1 8-Axis High-Performance MM4006 Motion Controller/Driver Version 7.01 Firmware ’ ANUAL www.newport.com...
- Page 2 This warranty is in lieu of all other warranties, expressed or implied, including any implied warranty of merchantability or fitness for a particular use. Newport Corporation shall not be liable for any indirect, special, or consequential damages. No part of this manual may be reproduced or copied without the prior written approval of Newport Corporation.
- Page 3 MM4006 8-Axis Motion Controller/Driver Table of Contents Warranty .........................ii Table of Contents....................iii Section 1 — Introduction Table of Contents ...................1.1 1.1 Safety Considerations................1.3 1.2 Conventions And Definitions ..............1.5 1.2.1 Symbols and Definitions.............1.5 1.2.2 Terminology.................1.6 1.3 General Description ................1.7 1.3.1 Features ..................1.9 1.3.2 Specifications................1.9...
- Page 4 3.2 Softwares....................3.5 3.2.1 MOTION Suite 32 .................3.5 3.2.2 MM4006 Terminal................3.6 3.2.3 MM4006 Servo................3.6 3.2.4 MM4006 XY Draw ................3.6 3.3 MOTION Suite 32 Quick Start ...............3.7 3.3.1 Installation of the MOTION Suite 32 .........3.7 3.3.2 PC/Controller Communication ..........3.9 3.3.3 Axis Motion Control ..............3.12 3.3.4 Acquisition .................3.13...
- Page 5 7.2.2 Increasing Performance..............7.5 7.2.3 Points to Remember ..............7.6 Section 8 — Appendices Table of Contents ...................8.1 Error Messages..................8.3 Error List ....................8.3 IEEE-488 Link Characteristics ...............8.6 IEEE-488 Functions Supported by MM4006 Controller......8.6 IEEE-488 Function Subsets ..............8.7 SRQ Using ....................8.7 EDH0181En1020 — 03/03...
- Page 6 Safety: EIC 1010-1, safety standards for measurement, lab and control equipment. Newport Corporation shall not be liable for damages when using the product: • Modification of the product. • Using modified connector, or modified or not supplied cables. • Connecting this product to non-CE equipment.
- Page 7 M M 4 0 0 6 8-Axis High-Per for mance Motion Controller/Driver CE Declaration of Conformity We declare that the accompanying product, identified with the “ ” mark, meets all relevant requirements of Directive: • 73/23/CEE, for Low Voltage Compatibility. •...
- Page 8 EDH0181En1020 — 03/03...