Clearing Alarm Indication; Erasing Data From Memory - AEMC CL601 User Manual

4.6

Clearing Alarm Indication

Clearing alarms can be performed in the STANDBY or RECORD mode.
1. Press and hold the PRESS button. When the ALARM (YELLOW) LED
lights up, release the button. The YELLOW LED will blink at a fast rate
for a period of five seconds.
2. Press the PRESS button for another 0.5 seconds to complete the
operation.
NOTE: This does not clear any stored alarms, only indications. Stored alarms
can only be cleared when memory is erased (see § 4.7).
4.7

Erasing Data from Memory

Erasing data from the instrument's memory can only be performed while
in the STANDBY mode.
There are two ways to erase the memory:
Erasing the Memory using the PRESS Button:
1. Press and hold the PRESS button. When the ERASE (RED) LED
lights up, release the button.
This will arm the instrument for an erase operation (when not in record
mode). While armed to erase memory, the RED LED will blink at a fast
rate for a period of five seconds.
2. Press the PRESS button for another 0.5 seconds to complete the
erase operation.
NOTE: If the button is not pressed within five seconds of arming, the erase
operation will automatically disarm and memory will be maintained. For this
reason, if you do not intend to erase memory, simply wait until the RED LED
stops blinking at the fast rate.
Erasing the Memory using the SLII Control Panel:
1. Connect the instrument to the computer, then open the SLII Control
Panel.
2. Select Erase Memory from the Instrument Menu.
14
Shop for AEMC products online at:
ShopAEMC
www.
Simple Logger II Model CL601
®
.com 1.888.610.7664