Epson XP-530/XP-630/XP-830 - Printer Manual

Also See for Small-in-One XP-530:

Quick start manual (4 pages)

Table of Contents

Contents

1 Start Here
2 Unpack
3 Turn on and configure
4 Install ink cartridges
5 Load paper
- 5.1 XP-630/XP-830
- 5.2 XP-530
6 Connect the fax line (XP-830)
7 Install software
8 Mobile printing
9 Any problems?
10 Any questions?
11 Need paper and ink?
12 Documents / Resources
- 12.1 References
- 12.2 Download manual

Epson XP-530/XP-630/XP-830 - Printer Manual

Start Here

Read these instructions before using your product.
The illustrations show the XP-830, but the steps are the same for the XP-530 and XP-630.

Unpack

(XP-630/XP-830)

warning Note:

Do not open ink cartridge packages until you are ready to install the ink. Cartridges are vacuum packed to maintain reliability.
The CD/DVD tray is taped to the bottom of cassette 2.

Remove all protective materials from the product.
Lift up the scanner unit and remove all protective materials.
Lower the scanner unit.

Turn on and configure

Connect the power cord to the back of the printer and to an electrical outlet.

Do not connect to your computer yet.
Turn on the product, then adjust the control panel.
Select these settings:
XP-530/XP-630: Language
XP-830: Language, country, date, and time

warning Note:

You can change these settings later using the product's control panel. For more information, see the online User's Guide.
If an error message appears, turn off the product and check that no protective material has been left inside the product.

Install ink cartridges

Lift up the scanner unit. Caution: Do not touch the flat, white cable.
Gently shake the Black (BK) ink cartridge. Do not shake Photo Black (PBK) or other ink cartridges.
Unpack the ink cartridges.

Do not touch the areas shown below. Doing so may prevent normal operation and printing.
Remove the cap from each ink cartridge. Store the caps in the included plastic bag.

Note: Save the caps and use them to recap the ink cartridges after removing them for storage or disposal.
Insert the cartridges at an angle in the holder for each color. Press each cartridge down until it clicks.
Lower the scanner unit.
The printer starts charging the ink. Ink charging takes approximately 7 minutes. When you see a completion message on the printer's LCD screen, charging is complete.

Don't turn off the printer or raise the scanner unit while the printer is charging or you'll waste ink.

warning Note:

The printer is designed for use with Epson^® cartridges only, not third-party cartridges or ink.
The cartridges included with the printer are designed for printer set up and not for resale. After some ink is used for charging, the rest is available for printing.

Load paper

See the online User's Guide for instructions on loading paper in the cassette 1 and rear paper slot, available paper types, sizes, loading capacity, and loading CD/DVD/Blu-ray^™ discs (XP-630/ XP-830).

XP-630/XP-830

Load paper - XP-630/XP-830
You can load the following paper sizes:

Cassette 1: 3.5 × 5-, 4 × 6-, or 5 × 7-inch photo paper
Cassette 2: Letter-size, A4-, legal-size, or 8 × 10-inch paper See the instructions below for loading paper.
Rear paper feed slot: One sheet at a time (XP-830)

XP-530

Load paper - XP-530
You can load the following paper sizes: 3.5 × 5-, 5 × 7-, 8 × 10inch, letter-size, A4-, or legal-size.

Lower the front cover (if it's not open already) and pull on the front cover to pull out the paper cassette.
Slide the side edge guides outward and set the front edge guide to the paper size you are using.
Insert the paper with the glossy or printable side facedown.

Note: Make sure the paper is loaded against the front edge guide and not sticking out from the end of the cassette.
Slide the side edge guides against the paper, but not too tight. Make sure the paper is under the tabs on the side edge guides.
Keep the cassette flat as you insert it all the way.
XP-530/XP-630: Pull out the output tray until it stops.

XP-830: The output tray is automatically ejected when you print. When you finish printing, press to close the tray.
Select the paper settings on the product's control panel, if prompted.

Connect the fax line (XP-830)

Connect the phone cord to a telephone wall jack and to the LINE port on your product. See the online User's Guide for more information.
Connect the fax line (XP-830)

Install software

warning Note: If your computer does not have a CD/DVD drive or you are using a Mac, an Internet connection is required to obtain the product software.

Make sure the product is NOT CONNECTED to your computer.

Windows^®: If you see a Found New Hardware screen, click Cancel and disconnect the USB cable.
Insert the product CD or download and run your product's software package:
XP-530: epson.com/support/xp530 (U.S.) or epson.ca/support/xp530 (Canada)
XP-630: epson.com/support/xp630 (U.S.) or epson.ca/support/xp630 (Canada)
XP-830: epson.com/support/xp830 (U.S.) or epson.ca/support/xp830 (Canada)
Follow the instructions on the screen to run the setup program.
OS X: Make sure you install Software Updater to receive firmware and software updates for your product.
When you see the Select Your Connection screen, select one of the following:

Wireless connection

In most cases, the software installer automatically attempts to set up your wireless connection. If setup was unsuccessful, you will be prompted to set up your wireless connection manually. Make sure you know your network name (SSID) and password.

Direct USB connection

Make sure you have a USB cable (not included).

Wired network connection (XP-830)

Make sure you have an Ethernet cable (not included).

When software installation is complete, restart your computer.

Mobile printing

Connect wirelessly from your tablet, smartphone, or computer. Print documents and photos from across the room or around the world. See your Quick Guide or visit epson.com/solutionsfinder.

Any problems?

Network setup was unsuccessful.

Make sure you select the right network name (SSID). The product can only connect to a network that supports 2.4 GHz.
If you see a firewall alert message, click Unblock or Allow to let setup continue.
If your network has security enabled, make sure you enter your network password (WEP key or WPA passphrase) correctly. Passwords must be entered in the correct case.

There are lines or incorrect colors in my printouts.
Run a nozzle check to see if any of the print head nozzles are clogged. Then clean the print head, if necessary. See the online User's Guide for more information.

The product's screen displays an output tray message.
Make sure the product's output tray is fully extended.

The product's screen is dark.
Press any button (XP-530 and XP-630) or touch the screen (XP-830) to wake your product from sleep mode.

Setup is unable to find my product after connecting it with a USB cable.
Make sure the product is turned on and securely connected as shown:
If setup is unable to find my product

Any questions?

Quick Guide
Basic information and troubleshooting.

User's Guide
Windows: Click the icon on your desktop or Apps screen to access the online User's Guide.

OS X: Click the icon in Applications/Epson Software/Guide to access the online User's Guide.

If you don't have a User's Guide icon, go to the Epson website, as shown below.

Technical support
epson.com/support (U.S.) or epson.ca/support (Canada)

(562) 276-4382 (U.S.) or (905) 709-3839 (Canada), 6 am to 8 pm, Pacific Time, Monday through Friday, and 7 am to 4 pm, Pacific Time, Saturday. Days and hours of support are subject to change without notice. Toll or long distance charges may apply.

Need paper and ink?

Try Epson specialty papers with Claria^® Ink for professional results. You can purchase them at epson.com/ink3 (U.S. sales) or epson.ca (Canadian sales). You can also purchase supplies from an Epson authorized reseller.
Call 800-GO-EPSON (800-463-7766).