Deactivating All Monitoring Functions: "Parking - Siemens SINUMERIK 828D Function Manual

A3: Axis Monitoring, Protection Zones
2.2 Axis monitoring
2.2.8

Deactivating all monitoring functions: "Parking"

If a machine axis is brought into the"Parking" state, then for this particular axis, no encoder actual values are
acquired, and all of the monitoring functions described in the preceding chapters (measuring system, standstill,
clamping monitoring etc. ) are deactivated.
Machine axis with measuring system
For a machine axis with measuring system, "parking" is activated by deselecting all measuring systems:
• DB31, ... DBX1.5 = 0 (position measuring system 1)
• DB31, ... DBX1.6 = 0 (position measuring system 2)
When the measuring systems are deactivated, the axis is no longer designated as being referenced:
• DB31, ... DBX60.4 = 0 (referenced / synchronized 1)
• DB31, ... DBX60.5 = 0 (referenced/synchronized 2)
Note
The axis must be re-referenced after the "Park" state has been canceled.
Machine axis without measuring system
For a machine axis without a measuring system (speed-controlled spindle), then a state corresponding to
"parking" is activated by withdrawing the controller enable:
• DB31, ... DBX2.1 = 0 (controller enable)
106
Function Manual, 09/2011, 6FC5397-0BP40-2BA0
Basic Functions