User Configuration Example - Lenovo CN4093 Application Manual

User Configuration Example

1. To configure a user with name "admin," authentication type MD5, and
authentication password of "admin," privacy option DES with privacy password
of "admin," use the following ISCLI commands.
2. Configure a user access group, along with the views the group may access. Use the
access table to configure the group's access level.
3. Assign the user to the user group. Use the group table to link the user to a
particular access group.
© Copyright Lenovo 2015
CN 4093(config)# snmp-server user 5 name admin
CN 4093(config)# snmp-server user 5 authentication-protocol md5
authentication-password
Changing authentication password; validation required:
Enter current admin password:
Enter new authentication password:
Re-enter new authentication password: <auth. password>
New authentication password accepted.
CN 4093(config)# snmp-server user 5 privacy-protocol des privacy-password
Changing privacy password; validation required:
Enter current admin password:
Enter new privacy password:
Re-enter new privacy password:
New privacy password accepted.
CN 4093(config)# snmp-server access 5 name admingrp
CN 4093(config)# snmp-server access 5 level authpriv
CN 4093(config)# snmp-server access 5 read-view iso
CN 4093(config)# snmp-server access 5 write-view iso
CN 4093(config)# snmp-server access 5 notify-view iso
Because the read view, write view, and notify view are all set to "iso," the user
type has access to all private and public MIBs.
CN 4093(config)# snmp-server group 5 user-name admin
CN 4093(config)# snmp-server group 5 group-name admingrp
If you want to allow user access only to certain MIBs, see "View-Based
Configuration," next.
<admin. password>
<auth. password>
<admin. password>
<privacy password>
<privacy password>
Chapter 36: Simple Network Management Protocol
537