Loading Software Via Bbi - Lenovo CN4093 Application Manual

5. The switch will prompt you to confirm your request.
6. When loading is complete, use the following commands to enter Global
Configuration mode to select which software image (image1 or image2) you want
to run in switch memory for the next reboot:
7. Reboot the switch to run the new software:

Loading Software via BBI

1. Click the Configure context tab in the toolbar.
2. In the Navigation Window, select System > Config/Image Control.
3. If you are loading software from your computer (HTTP client), skip this step and
go to the next. Otherwise, if you are loading software from an FTP, SFTP, or TFTP
server, enter the server's information in the FTP, SFTP, or TFTP Settings section.
4. In the Image Settings section, select the image version you want to replace (Image
for Transfer).
© Copyright Lenovo 2015
Once confirmed, the software will begin loading into the switch.
Router# configure terminal
Router(config)# boot image {image1|image2}
The system will then verify which image is set to be loaded at the next reset:
Next boot will use switch software image1 instead of image2.
Router(config)# reload
The system prompts you to confirm your request. Once confirmed, the switch
will reboot to use the new software.
You can use the Browser-Based Interface to load software onto the CN4093. The
software image to load can reside in one of the following locations:
 FTP server
 TFTP server
 SFTP server
 Local computer
After you log onto the BBI, perform the following steps to load a software image:
The Switch Image and Configuration Management page appears.
 If you are loading software from an FTP, SFTP, or TFTP server, enter the file
name and click Get Image.
If you are loading software from your computer, click Browse.

In the File Upload Dialog, select the file and click OK. Then click Download via

Browser.
Once the image has loaded, the page refreshes to show the new software.
Chapter 3: Switch Software Management
63