E_Ports - Lenovo CN4093 Application Manual

E_Ports

320
CN4093 Application Guide for N/OS 8.3
E_ports (expansion ports) connect two full fabric switches to form an inter-switch
link (ISL). Up to four Fibre Channel ISLs can be established between two full fabric
switches.
Only Fibre Channel port types can be configured as E-ports. These ports must be
members of a Fibre Channel VLAN. Use the following commands to configure
E_ports:
CN 4093(config)# system port <port range> type fc
CN 4093(config)# interface fc <port range>
CN 4093(config-if)# type e
To verify the port configuration and operational state, use the following command:
CN 4093(config)# show interface fc information
In a stack of switches, ports on the Master or Backup switches can be configured as
E-ports.
If different zones were configured on the switches being connected using E_ports,
the zones merge to establish a consistent zoning policy across the fabric. The zones
on the two switches must belong to any one zoneset.
Note: Zones are added in the merged zoneset only if the zoneset on the individual
switch was active.
The following table lists the zone merge rules:
Table 31.
Zone merge rules
Adjacent Zoning
Configuration
Zone Set State is
Deactivated.
Zone Set State is
Activated.
Adjacent Zone Set is equal to the Local Zone Set
Adjacent and Local Zone Sets contain a Zone with
the same name but different members.
Adjacent Zone Set contains Zones that are not
included in the Local Zone Set, and/or Local Zone
Set contains Zones that are not included in the
Adjacent Zone Set.
E-ports cannot be used to form stack LAG links.
Local Zoning
Configuration
Zone Set State is
Activated or
Deactivated.
Zone Set State is
Deactivated.
Result in Local Switch
No change
Zone Set gets the Adjacent
Zone Set State (i.e., the Zone
Set is activated).
Zone Set gets the adjacent
Zone Set.
No change
ISL Isolated.
Zone Set State becomes
Activated.
Zone Set is the merge of the
local Zones plus the
Adjacent Zones.