Task 2: Configure Cn4093 2 - Lenovo CN4093 Application Manual

Task 2: Configure CN4093 2

1. On CN4093 2, configure the interfaces for clients (174.14.20.111) and servers
(10.1.1.111).
2. Configure Virtual Interface Routers.
3. Enable VRRP Hot Standby.
4. Configure VRRP Group parameters. Use the default VRRP priority of 100, so that
this switch is the Standby.
5. Turn off Spanning Tree Protocol globally. .
© Copyright Lenovo 2015
CN 4093(config)# interface ip 1
CN 4093(config-ip-if)# ip address 174.14.20.111 (Define IPv4 address for interface 1)
CN 4093(config-ip-if)# enable
CN 4093(config-ip-if)# exit
CN 4093(config)# interface ip 2
CN 4093(config-ip-if)# ip address 10.1.1.111
CN 4093(config-ip-if)# enable
CN 4093(config-ip-if)# exit
CN 4093(config)# router vrrp
CN 4093(config-vrrp)# enable
CN 4093(config-vrrp)# virtual-router 1 virtual-router-id 1
CN 4093(config-vrrp)# virtual-router 1 interface 1
CN 4093(config-vrrp)# virtual-router 1 address 174.14.20.100
CN 4093(config-vrrp)# virtual-router 1 enable
CN 4093(config-vrrp)# virtual-router 2 virtual-router-id 2
CN 4093(config-vrrp)# virtual-router 2 interface 2
CN 4093(config-vrrp)# virtual-router 2 address 10.1.1.100
CN 4093(config-vrrp)# virtual-router 2 enable
CN 4093(config-vrrp)# hot-standby
CN 4093(config-vrrp)# group enable
CN 4093(config-vrrp)# group virtual-router-id 1 (Set Virtual Router ID for Group)
CN 4093(config-vrrp)# group interface 1
CN 4093(config-vrrp)# group track ports
CN 4093(config)# spanning-tree mode disable
(Define IPv4 address for interface 2)
(Enable Virtual Router Group)
(Set interface for Group)
(Enable tracking on ports)
Chapter 34: Virtual Router Redundancy Protocol
517